Hitachi P50H401, P55H401 Accessories, First time use, For U.S. models

Lift up on tab to remove back cover.

CAUTION: Do not insert batteries with ‘+’ and ‘-’ polarities reversed as this may cause the batteries to swell or rupture resulting in leakage.

Bottom View (Remote Control)

test-bleed 3/3/06 10:18 AM Page 4

First time use

Accessories

Check to make sure you have the following accessories before disposing of the packing material.

￿ Remote Control ￿ Two “AA” size, ￿ Power Cord

1.5V batteries

￿ Table Top Stand	￿ Table Top Stand
	(42” included)
(50" included)

For U.S. models:	Note: Please visit our
For optional accessories, please access our web site at:	website for optional
www.hitachi.us/tv	accessories.

CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the front glass panel. This plasma television product is designed for a maximum tilting angle of 45 degrees from vertical.

2.This stand for use only with Hitachi P42H401 and P50H401. Use with other apparatus is capable of resulting in instability causing possible injury.

3.The wall mount unit for the 50" and 42" models is WM07S and for the 55"models is WM07L. Please see page 7 for important information related to the wall mount. Wall Mout unit is an optional accessory (Not Included).

￿Remote Control Unit CLU-4371UG2 (Part No. HL02075).

￿Two "AA" size, 1.5V batteries (P# FQ00021).

￿Table Top Stand (UX27661 42" model)

(UX27281 50" models).

￿Power Cord (P# EV01841).

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1.Open the battery cover of the remote control by pushing down and sliding the back cover off.

2.Insert two new “AA” size batteries for the remote control. When replacing old batteries, push them towards the

springs and lift them out.

3. Match the batteries to the (+) and (-) marks in the battery compartment.

4.Insert the bottom of the battery, the (-) side, into the battery

compartment first, push towards the springs and insert the top of the battery, the (+) side, into place. Do not force the battery into the battery compartment.

5.Replace the cover.

4