Advanced Techniques
•Never use the DC camera light in the vicinity of explosive or highly flammable materials.
•Always allow the DC camera light to cool fully before storing.
•The DC camera light becomes very hot during use of the camera light or immediately after use. Be careful that your hand or hair does not touch them.
•When the DC camera light is on, avoid subjecting the camera light to impacts or sharp vibrations.
•If the DC camera light is turned on and off during recording, there could be noise in the picture. Watch the battery charge indicator especially when using a battery as the power source.
•When the DC camera light is used, the operation time of the camcorder when a fully- charged battery pack is attached is halved.
Removing the DC Camera Light
Depress the light to release the tab from the hook and then move the light in the direction of the arrow as shown in the figure.
Replacing the DC Camera Light Bulb
1.Turn the front of the case
2.Remove the bulb by pulling it out through the opened case.
3.Install the new bulb by aligning the notch in the rim of the bulb's base with the "
" mark outside the socket. Avoid touching the bulb directly with your fingers. It may shorten the life of the bulb.
4.Reattach the front of the case by placing the bulb in the hole of the reflective plate, lining up the smaller