Getting Started

 

Battery pack

 

 

Recording

LCD monitor VM-BPL13

VM-BPL27

Continuous

OFF

120 min.

270 min.

recording

ON

100 min.

220 min.

Typical

OFF

70 min.

160 min.

recording

ON

60 min.

130 min.

Notes on the Battery

•It is recommended that the battery always be left in the discharged state when not in use, and charged before you use it.

•Avoid storing a fully charged battery, and do not store it in a place where the temperature is high: this will damage the battery.

•Do not operate the battery at temperature below 14°F (-10°C) or above 113°F (45°C). At extremely low temperatures operation time decreases, while at high temperature the battery may be damaged.

•If the POWER lamp begins to flash during charging, remove the battery and then reattach it to the AC adapter/charger. If the POWER lamp continues to flash after several attempts to attach it, the battery is unable to take a charge and must be replaced.

•Do not attach a hot battery to the AC adapter/charger. Allow it to cool. Attaching a hot battery to the AC adapter/charger causes the POWER lamp to flash.

THERE ARE NO USER-SERVICEABLE PARTS INSIDE THE BATTERY OR AC

ADAPTER/CHARGER.

THROWING THE BATTERY INTO FIRE OR EXPOSING IT TO EXCESSIVE HEAT

(ABOVE 140°F [60°C]) MAY CAUSE INJURY.

SHORTING THE BATTERY'S TERMINAL INCREASES RISK OF FIRE OR

ELECTRICAL SHOCK.

Camcorder Batteries

Using Battery Pack

Before uyou install the battery for the first time it must be fully charged. Seee "Charging the Battery" on page 15 for details.

1.Align the bottom of the battery with mark on the camcorder so that the battery fits into the grooves.

2.Slide the battery downward, as illustrated.

Note: Alwys remove the battery from the camcorder after use.

Note: We cannot guarantee against malfunctions of the camcorder which occur when you use battery packs othe than those specified.

Note: Always attach a battery bythe procedure described here. Attaching a battery forcibly

20