Hitachi X200 Series instruction manual 30

2−30

If the Potentiometer Enable LED is OFF, follow these steps below.

Inverter Mounting and installation

		Action	Display			Func./Parameter
(Starting point)
				A- - -	“A” Group selected
	FUNC
Press the		key.		A001	Speed command source setting
					00	= Keypad potentiometer
	FUNC				01	= Control terminals
Press the		key again.		01	02	= Function F001 setting
					03	= ModBus network
					04	= Calculate function output
Press the	2	key.		00	00	= Potentiometer (selected)
	STR				Store parameter, returns to “A”
Press the		key.		A001
					Group list

Select the Keypad for RUN Command – To RUN command causes the inverter to accelerate the motor to the selected speed. The Run command can arrive

Run Key Enable LED

from various sources, including the control terminals, the Run key on the keypad or the network. In the figure to the right, notice the Run Key Enable LED, just above the Run key. If the LED is ON, the Run key is already selected as the source, and you may skip this step. Note that the default setting depends on the country.

STOP

RUN RESET

FUNC 1

Hz POWER

A ALARM

RUN

PRG

2 STR

If the Potentiometer Enable LED is OFF, follow these steps below (the table resumes action from the end of the previous table).

		Action	Display			Func./Parameter
(Starting point)					Speed command source setting
				A001
Press the		key once.			Run command source setting
	1			A002
	FUNC				01	= Control terminals
Press the		key.		01	02	= Run key on keypad
					03	= ModBus network
Press the	1	key.		02	02	= Run key on keypad (selected)
	STR				Store parameter, returns to “A”
Press the		key.		A002
					Group list

NOTE: After completing the steps above, the Run Key Enable LED will be ON. This does not mean the motor is trying to run; it means that the RUN key is now enabled. DO NOT press the RUN key at this time – complete the parameter setup first.