– 12 –
CHEMICAL SANITIZER (LXiC AND LXiGC)
CAUTION: Items such as pewter, aluminum and silver will be attacked by sodium hypochlorite
(bleach). Therefore, chemical-sanitizing dishwashers should not be used to wash such items.
On model LXiC only, the chemical sanitizer pump is factory-set for use with 6% sodium hypochlorite
solution. If 8.40% sodium hypochlorite solution is to be used, contact your local Hobart Service
Office.
Place a 1-gallon bottle of 6% or 8.40% sodium hypochlorite solution (bleach) in a suitable location no
higher than 10 inches off the floor. Do not pre-mix sanitizing solution with water or any other liquid.
WARNING: NEVER PREMIX A WETTING AGENT WITH THE SANITIZING SOLUTION. MIXING
MAY CAUSE HAZARDOUS GAS TO FORM.
Remove the sanitizer bottle cap and place the

white

delivery tube in the sanitizer container. Be sure
to push the delivery tube standpipe completely to the bottom of the container. Check to make sure there
are no obstructions or kinks in the delivery tube.
The LXi Series Dishwasher has an auto-prime cycle. (See Operating the LXi Dishwasher.)
Frequently check your sanitizer bottle to make sure there is a sufficient chemical supply.
OPERATION
CAUTION: Items such as pewter, aluminum and silver will be attacked by sodium hypochlorite
(bleach). Therefore, chemical-sanitizing dishwashers should not be used to wash such items.
If your dishwasher is a chemical-sanitizing model, frequently check the sanitizer bottle to make sure
there is a sufficient chemical supply.
BEFORE FIRST USE
This machine must be cleaned after installation and before being put into operation. (See Cleaning.)
CONTROLS
Fig. 6