SB2040
Snowblower
5/16"
HEX BOLT
(4
5/16''
LOCK
L
-
SHAPED BRACKET ON
Install
Brackets
1. If already installed, remove the hardware and
the I-shaped brackets from the subframe of the
assembled snowblower.
2.
Install the I
-
shaped brackets to the lawn tractor
frame using two 5/16 x
3/4" bolts and 5/16"
lock
washers as shown. Make sure the I
-
shaped
brackets are installed on the outside of the
lawn tractor frame.
from the subframe.
3. Remove the u
-
shaped bracket and hardware
'
N
I/
I
RIGHT SIDE OF TRACTOR FRAME
L
-
SHAPED BRACKET ON
4. Loosely install (don't tighten) the u
-
shaped
bracket to the
two
I
-
shaped brackets using four
3/8 x 1"
I
hex bolts and 3/8" lock washers.
5.
Raise the height adjustment lever as far as
possible.
3/8
x
1
"
HEX BOLT
(4)
Install the Snowblower
1.
Position the snowblower assembly directly in
front of the lawn tractor. Raise and support the
blower head, then slide the snowblower
assembly user the lawn tractor
so
the
subframe holes are about 1/4" further back
from their corresponding holes in the u-shaped
bracket.
2.
Lower the height adjustment lever all the way
down.
3. Connect the
lift
plates to the rear lift arms on
the lawn tractor using the same spring clips
and flat washers used for the mower deck.
SPRING CLIP
(2)
FLAT WASHER
(2)
from
MOWER
DECK
LIFTING ARM
(2)
(on lawn tractor frame)
POP
52152
(9610)
15