Removing the Snowblower SB2040
Snowblower
Removing
the
Snowblower
1.
2.
3.
4.
Make sure the PTO clutch lever is
OFF.
Drive the lawn tractor to a flat, level surface, turn the engine
off,
remove the ignition key and set the
parking brake
ON.
Disconnect the spark plug cap. Lower the height adjustment lever all the way down.
Raise the front tires and support them squarely on top of
two
4 x 4"
blocks of wood.
DRIVE BELT SILVER
Remove the silver
-
colored bolt that holds the
engine pulley belt guard to the right side of the
lawn tractor frame. Allow the belt guard to fall
down slightly, then remove the snowblower
drive belt from the engine pulley.
BELT GUARD
PIVOT PLATE ON
U
-
SHAPED BRACKET
5.
Loosen the jam nut on the belt tension
FRONT
turnbuckle, then lengthen the turnbuckle
enough to disconnect the J
-
bolt from the
PTO
pivot plate.
LOOSEN JAM NUT
REMOVE HOOK BOLT
6. Remove the 2 x 40 mm spring clip and two flat
washers from the PTO connecting rod where it
is connected to the PTO pivot plate. Allow the
rod to fall clear from the pivot plate. Retain the
spring clip and washers when reinstalling the
snowblower or the mower deck.
FLAT WASHER
(2)
and
2x26mm
SPRING CLIP
30
POP
52152 (9610)