INSTALLATION

Full Speed USB

1.Turn off the host device.

2.Plug the male 10-pin RJ45 end of the USB cable into the 10-pin socket on the 7120.

3.Plug the other end of the USB interface cable into the host device’s USB port.

4.Turn on the host device.

When the scanner first receives power, the blue and white LED will toggle on and off then the scanner will beep once.

Figure 13.

As a default, the MS7120-38leaves the factory with USB Keyboard Emulation Mode enabled. Scan the following bar code to configure the MS7120-38 for USB Serial Emulation Mode.

³ 3 1 6 4 6 0

Plugging the scanner into the USB port of the PC does not guarantee that scanned information will appear at the PC. A software driver and the correct configuration settings are also required for proper communication to occur.

For Previous User’s of the MX009

In order for the new integrated USB Orbit* to function with the same serial emulation driver as the old external USB Orbit, scan the following bar code.

* Rev L Orbits or above.

³ 3 1 6 4 7 0

11