Honeywell N7003V3 manual Bypassing Protection Zones, BYPASS Key, Using the

Bypassing Protection Zones

Using the

6 BYPASS Key

This key is used when you want to arm your system with one or more zones intentionally unprotected. Bypassed zones are unprotected and will not cause an alarm when violated while your system is armed. All bypasses are removed when an OFF sequence (security code plus OFF) is performed. Bypasses are also removed if the arming procedure that follows the bypass command is not successful.

Note: The system will not allow fire or emergency zones to be bypassed.

To bypass zones, the system must be disarmed first.

BYPASS

1. Enter your security code and press 6 .

2.Enter zone number(s) for the zones to be bypassed (e.g., 01, 02, 03, etc.). Important! All single-digit numbers must be preceded by “0” (for example, enter 01 for zone 1).

3.

BYPASS 07 FRONT UPSTAIRS BEDROOM

Typical bypass message

When finished, the keypad will display the word BYPASS along with each bypassed zone number. Wait for these zones to be displayed before arming. Arming the system before bypassed zones are displayed eliminates all bypasses.

4.	DISARMED BYPASS	Arm the system as usual when the keypad
	READY TO ARM	displays "ready" to arm message.

– 24 –