HP 100 CE866ARBGJ manual Connect to a network by using the software CD-ROM network models only

Models: 100 CE866ARBGJ

1 220
Download 220 pages 58.76 Kb
Page 53
Image 53
Connect to a network by using the software CD-ROM (network models only)

Connect to a network by using the software CD-ROM (network models only)

The product can connect to wired or wireless networks.

Supported network protocols NOTE: You cannot connect to a wired and wireless network simultaneously. Wired connections take precedence.

Supported network protocols

Network models support the TCP/IP protocol, which is the most widely used and accepted networking protocol. Many networking services utilize this protocol. This product also supports IPv4 and IPv6. The following lists shows the networking services/protocols that are supported on the product.

TCP/IP (IPv4 or IPv6)

Port 9100

LPR

DHCP

AutoIP

SNMP

Bonjour

SLP

WSD

NBNS

Install the product on a wired network

Configure the IP address

The product IP address can be set manually, or it can be configured automatically via DHCP, BootP, or AutoIP.

Manual configuration

Only the IPv4 protocol can be configured manually.

1.On the control panel, press the Setup Install the product on a wired network button.

2.Use the arrow buttons to select Network Setup, and then press the OK button.

3.Use the arrow buttons to select TCP/IP Config, and then press the OK button.

4.Use the arrow buttons to select Manual, and then press the OK button.

5.Use the arrow buttons to set the IP address, and then press the OK button.

6.If the IP address is incorrect, use the arrow buttons to select No, and then press the OK button. Repeat step 5 with the correct IP address, and then repeat step 5 for the subnet mask and default gateway settings.

ENWW

Connect to a network by using the software CD-ROM (network models only) 39

Page 53
Image 53
HP 100 CE866ARBGJ manual Connect to a network by using the software CD-ROM network models only, Supported network protocols