|
|
| Chapter 3 – Related MultiVOIP Setup Parameters | |
|
|
|
|
|
|
| DID Interface Parameter Definitions |
| |
|
|
|
|
|
| Field Name | Values | Description |
|
|
|
|
|
|
| Interface | Enables the |
| |
|
|
|
|
|
| DID Options | MultiVOIP’s use of DID applies only for incoming DID calls. The |
| |
|
|
| Start Mode used by the MultiVOIP must match that used by the |
|
|
|
| originating telephony equipment, else DID calls cannot be |
|
|
|
| completed. |
|
|
|
|
|
|
| Start Modes | Immediate Start, | For Immediate Start, the voip detects the |
|
|
| Wink Start, | by the telco |
|
|
| Delay Dial | digits immediately. |
|
|
|
| For Wink Start, the voip detects the |
|
|
|
| voip reverses battery polarity for a specified time |
|
|
|
| “wink”) and then becomes ready to receive dial digits. |
|
|
|
| For Delay Dial, the voip detects detects the |
|
|
|
| the voip reverses battery polarity for a specified time (reverse |
|
|
|
| polarity duration has wider acceptable range than for Wink Start) |
|
|
|
| and then becomes ready to receive dial digits. |
|
|
|
|
|
|
| Wink Timer | integer values, | This is the length of the wink for Wink Start and Delay Dial signaling |
|
| (in ms) | in milliseconds | modes.. |
|
|
|
| Applicable only when Start Mode parameter is set to “Wink Start” or |
|
|
|
| “Delay Dial.” |
|
|
|
|
|
|
| Dialing Options |
|
| |
| Inter Digit | integer values, | This is the length of time that the MultiVOIP will wait between |
|
| Timer | in seconds | digits. When the time expires, the MultiVOIP will look in the |
|
|
|
| phonebook for the number entered. |
|
|
|
| Default = 2. |
|
|
|
|
|
|
| Message | Not applicable to |
| |
| Waiting |
|
|
|
| Indication |
|
|
|
|
|
|
|
|
| integer values, | This parameter is applicable when digits are dialed onto a |
| |
| Regeneration | in milliseconds | channel after the connection has been made. The length of time |
|
| Timer |
| between the outputting of DTMF digits. |
|
|
|
| Default = 100 ms. |
|
|
|
|
|
|
50 |