|
|
|
|
| TM | |||||
your local | ||||||||||
rear of this manual for addresses). Specify the | ||||||||||
model number, serial number prefix, and HP part | ||||||||||
ply. Additional manuals may be purchased from | number shown on the title page. |
| ||||||||
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| |
INPUT: |
| METERS: |
|
|
|
|
|
|
| |
230Vac *10%, single phase, | A front panel voltmeter | |||||||||
2500W @ 230V. |
| (Accurate within 2% of full | ||||||||
OUTPUT : |
| scale. ) |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| ||
OUTPUT CONTROLS: |
|
|
|
| ||||||
|
|
|
|
|
| |||||
LOAD REGULATION: | coarse | and | fine | voltage and current | ||||||
controls are | included | on | the | front panel. | ||||||
Constant Voltage - Less than 0.01% plus 200µV | ||||||||||
|
|
|
|
|
|
|
| |||
for a load current change equal to the current | OUTPUT TERMINALS: |
|
|
|
| |||||
rating of the supply. |
|
|
|
| ||||||
Constant Current - Less than 0.02% plus 2mA | Output bus bars are located on the rear of the | |||||||||
for a load voltage change equal to the voltage | chassis. Both bus bars are isolated from the | |||||||||
rating of the supply. | chassis and either the positive or negative bus | |||||||||
|
| bar may be connected to the chassis through a | ||||||||
LINE REGULATION : | separate, | adjacent | ground terminal. |
| ||||||
Constant Voltage - Less than 0.01% plus 200µV | REMOTE VOLTAGE PROGRAMMING: |
| ||||||||
for a change in line voltage from 207 to 253 volts |
| |||||||||
All programming terminals are on a rear | ||||||||||
at any output voltage and current within rating. | ||||||||||
barrier strip. |
|
|
|
|
|
| ||||
Constant Current - Less than 0.02% plus 2mA |
|
| 1V/volt | (accuracy: 1%). | ||||||
Constant | Voltage | - | ||||||||
for a change in line voltage from 207 to 253 volts | ||||||||||
Constant | Current | - 10mV/amp (Accuracy 10%). | ||||||||
at any output voltage and current within rating. | ||||||||||
|
|
|
|
|
|
|
| |||
RIPPLE AND NOISE: | REMOTE RESISTANCE PROGRAMMING: | |||||||||
All programming terminals are on a rear | ||||||||||
Constant Voltage - Less than 1mV rms, 5mV | ||||||||||
barrier strip. |
|
|
|
|
|
| ||||
|
|
|
|
|
| |||||
Constant | Voltage | ohms/volt | (Accuracy: | |||||||
Constant Current - Less than 25mA rms. | 1%). |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| ||
TEMPERATURE RATINGS: | Constant | Current | ohms/ampere | (Accuracy | ||||||
10%). |
|
|
|
|
|
|
| |||
Operating: O | to 55°C. Storage: |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |||
TEMPERATURE | COEFFICIENT: | OVERVOLTAGE PROTECTION CROWBAR: | ||||||||
The minimum crowbar trip setting above the | ||||||||||
Constant Voltage - Less than O .01% plus 200µV | desired operating output voltage” to prevent false | |||||||||
change in output per degree Centigrade change in | crowbar tripping is 5% of output voltage setting | |||||||||
ambient following 30 minutes | plus 2 volts. Range is 4 to 45Vdc. |
| ||||||||
Constant Current - Less than 0.01% plus 4mA |
|
|
|
|
|
|
|
| ||
change in output per degree Centigrade change in | COOLING: |
|
|
|
|
|
|
| ||
ambient following 30 minutes |
|
|
|
|
|
|
| |||
Forced air cooling is employed. The supply has | ||||||||||
|
| |||||||||
STABILITY : |
| two cooling | fans. |
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| ||
Constant Voltage - Less than O .03% plus 2mV | WEIGHT: |
|
|
|
|
|
|
| ||
total drift for 8 hours following 30 minutes warm- |
|
|
|
|
|
|
| |||
up under constant ambient conditions. | 95 lbs. (43.0 kg.) | net. | 120 lbs. | (54.5 kg.) | ||||||
Constant Current- Less than 0.03% plus 10mA | shipping. |
|
|
|
|
|
|
| ||
total drift for 8 hours following 30 minutes warm- | SIZE: |
|
|
|
|
|
|
| ||
up under constant ambient conditions. |
|
|
|
|
|
|
| |||
|
| 7.0“ (17.8cm) H x 17.511 (44.4cm) D x 19.0” | ||||||||
TRANSIENT RECOVERY TIME: | (48, 3 cm) W. The unit can be mounted in a | |||||||||
Less than 50µsec is required for output voltage | standard 19” | rack panel. |
|
|
| |||||
recovery (in constant voltage operation) to within |
|
|
|
|
|
|
|
| ||
10mV of the nominal output voltage following a | FINISH: |
|
|
|
|
|
|
| ||
S ampere change in output current. | Light gray front panel with dark gray case. | |||||||||
|
|
|
|
|
|
|
|
|
|