Command Line Interface Reference Guide

aaa

 

 

Configure how traffic is controlled on non-authenticated ports; in

BOTH directions (ingress+egress) or IN only (ingress).

Supported Values:

■both -- Exert control in both directions.

■in -- Exert control on incoming packets.

dhcp-addr

■aaa port-access web-based dhcp-addr IP-ADDR/MASK-LENGTH

Set the base address / mask for the temporary pool used by DHCP (base address default is 192.168.0.0, mask default is 24 - 255.255.255.0).

dhcp-lease

■aaa port-access web-based dhcp-lease < 5 to 25 >

Set the lease length of the IP address issued by DHCP (default 10).

Range: < 5 to 25 >

enable

■aaa authentication console enable

Configure access to the privileged mode commands.

Next Available Option:

■primary < local tacacs radius > -- Specify the primary authentication method for access control.(p. 44)

■aaa authentication telnet enable

Configure access to the privileged mode commands.

Next Available Option:

■primary < local tacacs radius > -- Specify the primary authentication method for access control.(p. 44)

■aaa authentication web enable

Configure access to the privileged mode commands.

Next Available Option:

■primary < local radius > -- Specify the primary authentication method for access control.(p. 44)

■aaa authentication ssh enable

Configure access to the privileged mode commands.

Next Available Option:

■primary < local tacacs radius ... > -- Specify the primary authentication method for access control.(p. 44)

© 2009 Hewlett-Packard Development Company, L.P.

33