Service Calibrations

17The Printer prompts you to remove the media.

18The Printer prompts you to lower the media lever.

If the Paper Advance Calibration fails for any reason, a warning message will appear on the Front Panel. In this case, try the following:

„Retry the Paper Advance Calibration.

„If necessary, perform a Printhead Recovery through the Front Panel and retry the calibration.

Remove the pattern from the printer and leave it to dry for a few minutes before continuing with the Calibration.

MAKE SURE NO MEDIA IS LOADED INTO THE PRINTER BEFORE STARTING TO SCAN THE CALIBRATION PATTERN.

19You will need to re-enter the Paper Advance Calibration submenu and scroll to Scan Calibration Pattern and press OK.

20When the following message appears on the front panel, you must select whether you would like to continue with the calibration by pressing the OK key. Press Back or Cancel to exit the calibration.

21A message will appear advising you that you will need to load the Calibration Pattern in to the Printer. Make sure that you rotate the printed

4-10

HP Designjet T Series — Service Manual