Getting Started
Diagnostic Front Panel LEDs and Audible Codes
|
| Possible | Recommended | |
Activity | Beeps | Cause | Action | |
|
|
|
|
|
Red Power LED | 9 | System powers on | 1. | Check that the |
flashes nine |
| but is unable to |
| voltage selector, |
times, once every |
| boot. |
| located on the rear of |
second, followed |
|
|
| the power supply |
by a |
|
|
| (some models), is set |
pause. The beeps |
|
|
| to the appropriate |
continue for five |
|
|
| voltage. Proper |
iterations, then |
|
|
| voltage setting |
stop. The LED |
|
|
| depends on your |
flashes continue |
|
|
| region. |
until the problem |
|
| 2. | Replace the system |
is resolved. |
|
| ||
|
|
| board. | |
|
|
|
| |
|
|
| 3. Replace the | |
|
|
|
| processor. |
|
|
|
|
|
Red Power LED | 10 | Bad option card. | 1. | Check each option |
flashes ten times, |
|
|
| card by removing the |
once every |
|
|
| card (one at a time if |
second, followed |
|
|
| multiple cards), then |
by a |
|
|
| power on the system |
pause. The beeps |
|
|
| to see if fault goes |
continue for five |
|
|
| away. |
iterations, then |
|
| 2. | Once a bad card is |
stop. The LED | identified, remove | |
flashes continue | ||
and replace the bad | ||
until the problem | ||
option card. | ||
is resolved. | ||
3. Replace the system | ||
| ||
| board. | |
|
|
Getting Started | 31 |