♦Setting Up Your Printer
2.0 Checking Voltage Selection
The standard Printer is configured for 115 VAC ± 10% single- phase 50/60 Hz with a properly-grounded outlet. A small sticker next to the power cord connection indicates the power requirements.
For international markets, there is a 230 VAC version available. If you are uncertain about the configuration of your Printer, or the outlet you are connecting to, check with a qualified service technician to verify the installation before connecting power.
2.1 Power Up Self-Test
Once labels are installed in the Printer as described in Section 1.6, a Self-Test should be performed. The Printer will power up in the Self-Test Mode when the feed button is pressed as the Printer is being turned on. Initial power up will take approximately 7 seconds. The Printer should be loaded with 4.25" (108 mm) wide stock whenever this test is conducted. The Self-Test prints across the entire width of the Printhead. Expect a brief hesitation of up to 15 seconds before the Self-Test begins to print.
DMX 400/430 Operator’s Manual | 16 |