Table 9.11 Error Messages (9 of 11)
Error Code and | Description |
Message |
|
|
|
50 TFTP LOCAL | The TFTP transfer of the configuration file from the host to |
ERROR | the HP Jetdirect print server failed with the local print server |
| encountering some form of inactivity timeout, or excessive |
| retransmissions situation. |
|
|
51 TFTP RETRIES | The overall retrying of the TFTP transfer of the configuration |
EXCEEDED | file from the host to the HP Jetdirect print server has |
| exceeded a retry limit. |
|
|
52 BAD BOOTP/DHCP | An error was detected in the BOOTP or DHCP reply that the |
REPLY | HP Jetdirect print server received. The reply either had |
| insufficient data in the UDP datagram to contain the |
| minimum BOOTP/DHCP header of 236 bytes, had an |
| operation field that was not BOOTPREPLY(0X02), had a |
| header field that did not match the print servers hardware |
| address, or had a UDP source port that was not the |
| BOOTP/DHCP server port (67/udp). |
|
|
53 BAD BOOTP | The tagsize in a |
TAG SIZE | is either 0, or greater than the remaining number of |
| unprocessed bytes in the |
|
|
54 BOOTP/RARP | The HP Jetdirect print server is currently in the process of |
IN PROGRESS | obtaining its basic IP configuration information through |
| BOOTP/RARP. |
|
|
55 BOOTP/DHCP | The HP Jetdirect print server is currently in the process of |
IN PROGRESS | obtaining its basic IP configuration information through |
| BOOTP/DHCP, and has not detected any errors. |
|
|
56 DHCP NAK | The HP Jetdirect print server received a negative |
| acknowledgement message from the DHCP server in |
| response to a configuration request. |
|
|
57 UNABLE TO | The HP Jetdirect print server had received IP parameters |
CONNECT DHCP SVR | from a DHCP server, but communication with the DHCP |
| server has been lost. Check status of the DHCP server. |
| If an infinite lease was assigned, the print server will use the |
| IP address of the most recent DHCP server used, but |
| operation may be degraded until a DHCP server responds. |
|
|
58 POSTSCRIPT | The printer does not support AppleTalk or AppleTalk |
MODE NOT | extensions. |
SELECTED |
|
|
|
59 INCOMPLETE F/W - | Firmware download message. Currently downloading |
MUST DOWNLOAD | firmware to the HP Jetdirect print server, or the download |
| did not complete properly. |
|
|
5A TURN PRINTER | Firmware download message. Download of firmware is |
OFF / ON | complete. Power off/on the HP Jetdirect print server. |
|
|
ENWW | HP Jetdirect Configuration Page 233 |