Table 3.4 Telnet Commands and Parameters (12 of 18)

phone-home-config

Specifies privacy settings on the print server during

 

embedded Web server access. This command controls

 

whether statistical data on product use may be sent to HP.

 

For HP to collect data, Internet access is required.

 

2: Prompt the user to allow sending data on initial access to

 

the Networking tab of the embedded Web server. This is the

 

factory-default and cold-reset value. Once changed, this

 

value cannot be re-selected.

 

1: Allows the sending of data to HP without prompting the

 

user.

 

0: Disables sending data to HP without prompting the user.

 

 

TCP/IP Diagnostics

 

Command

Description

 

 

Last Config IP

(Read-only parameter) The IP address of the system from

 

which the HP Jetdirect print server’s IP address was

 

configured.

 

 

TCP Conns Refused

(Read-only parameter) The number of client TCP

 

connections that are refused by the print server.

 

 

TCP Access Denied

(Read-only parameter) The number of times that client

 

systems were denied access to the print server because

 

there was no allowable entry in the print server’s host access

 

list.

 

 

DHCP Lease Time

(Read-only parameter) DHCP IP address lease duration

 

time (seconds).

 

 

DHCP Renew Time

(Read-only parameter) DHCP T1 timeout, specifying the

 

DHCP lease renewal time (seconds).

 

 

DHCP Rebind Time

(Read-only parameter) DHCP T2 timeout, specifying the

 

DHCP lease rebind time (seconds).

 

 

SNMP

 

Command

Description

 

 

snmp-config

Enables or disables SNMP operation on the print server.

 

0 disables, 1 (default) enables SNMP.

 

CAUTION: Disabling SNMP will disable all SNMP agents

 

(SNMP v1, v2, v3) as well as communications with

 

management applications, such as HP Web Jetadmin. In

 

addition, firmware upgrades through current HP

 

downloading utilities will be disabled.

 

 

get-cmnty-name

Specifies a password that determines which SNMP

 

GetRequests the HP Jetdirect print server will respond to.

 

This is optional. If a user-specified get community name is

 

set, the print server will respond to either a user-specified

 

community name or the factory-default. The community

 

name must be ASCII characters. The maximum length is

 

255 characters.

 

 

ENWW

TCP/IP Configuration 90