CLI commands

„IP address or domain name (up to 107 characters in length)

„Subnet address. Include the network mask as follows: address/subnet mask For example: 192.168.30.0/24

„Use the keyword all to match any address.

„Use the keyword none if the protocol does not take an address range (ICMP for example).

<port>

Specify a specific port to check or a port range as follows:

„none: Used with ICMP (since it has no ports).

„all: Check all ports.

„1-65535[:1-65535] - Specify a specific port or port range.

<account>

Specify the name of the user account the service controller will send billing

 

information to for this rule. Account names must be unique and can be up

 

to 32 characters in length.

<interval>

Specify time between interim accounting updates. If you do not enable this

 

option, accounting information is only sent when a user connection is

 

terminated. Range: 5-99999 seconds in 15 second increments.

use access-list

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

use access-list <listname>

Specifies the name of the access list to use.

no use access-list

Do not use an access list.

use access-list unauth

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

use access-list unauth <listname>

Specifies the name of the access list to use for unauthenticated stations (list disappears once authenticated).

no use access-list unauth

Do not use an access list for unauthenticated stations (list disappears once authenticated).

config file

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

config file <url>

Specifies the URL that points to a new configuration file to load.

no config file

Do not load a new configuration file.

2-56