Error message | Probable Cause |
Diskette Drive A or B Error | Drive A: or B: is present, but |
| fails the BIOS POST diskette |
| tests. |
Recommended Action
1.Run Setup.
2.Replace the signal cable.
3.Replace the drive.
Extended RAM Failed at | Extended memory is not |
Offset, nnn | working or is not configured |
| properly. |
Failing Bits nnn | nnn is a map of the bits at the |
| RAM address which failed the |
| memory test. |
Fixed Disk 0 or 1 Failure | Hard drive is not working or is |
| not configured properly. |
Fixed Disk Controller | Hard drive is not working or is |
Failure | not configured properly. |
Incorrect Drive A Type | Type of diskette in drive A: is |
| not correctly identified. |
Invalid NVRAM Media Type | Problem with NVRAM |
| (CMOS) access. |
Keyboard Controller Error | Keyboard, I/O keyboard |
| controller (on system board), |
| or mouse error. |
Keyboard Error | Keyboard, I/O keyboard |
| controller (on system board), |
| or mouse error. |
Operating System Not | Operating system cannot be |
Found | located on either drive A: or |
| C:. |
Parity Check 1 | Parity error found in the |
| system bus. |
Parity Check 2 | Parity error found in the I/O |
| bus. |
1.Replace the memory modules.
2.Replace the system board.
1.Run Setup.
2.Replace the system board.
1.Run Setup.
2.Replace the signal cable.
3.Replace the hard drive.
1.Run Setup.
2.Replace the system board.
1.Run Setup.
2.Replace the diskette drive.
Replace the system board.
1.Replace the keyboard.
2.Replace the mouse.
3.Replace the system board.
1.Replace the keyboard.
2.Replace the mouse.
3.Replace the system board.
Run Setup.
1.Run Setup.
2.Replace the memory modules.
3.Replace the system board.
1.Run Setup.
2.Replace the ISA board (modem).
Real Time Clock Error | Replace the system board. | ||
| test. |
|
|
System Battery is Dead | RTC battery is dead. | 1. | Replace the RTC battery. |
|
| 2. | Run Setup. |
Continued