Figure 18 Sample
Enter data in Section 2 as follows:
1.Enter a name for the recovery group following the RECOVERY_GROUP_NAME keyword. This can be any name you choose.
2.After the PRIMARY_PACKAGE keyword, enter a primary package definition consisting of the cluster name followed by a slash (/) followed by the package name. Example:
PRIMARY_PACKAGE LAcluster/custpkg
3.Optionally, enter a data sender package definition consisting of the cluster name, a slash (/), and the data sender package name after the DATA_SENDER_PACKAGE keyword. This is only necessary if you are using a logical data replication method that requires a data sender package.
4.After the RECOVERY_PACKAGE keyword, enter a recovery package definition consisting of the cluster name followed by a slash (/) followed by the package name. Example:
RECOVERY_PACKAGE NYcluster/custpkg_bak
5.Optionally, enter a data receiver package definition consisting of the cluster name, a slash (/), and the data receiver package name after the DATA_RECEIVER_PACKAGE keyword. This is only necessary if using a logical data replication method that requires a data receiver package.
6.Optionally, enter a rehearsal package definition consisting of the cluster name, a slash (/), and the rehearsal package name after the REHEARSAL_PACKAGE keyword. This is only required for performing a rehearsal operation at the recovery cluster.
7.Repeat these steps for each package that will be recovered. Each package must be configured in a separate recovery group.
80 Designing Continentalclusters