# cmrecovercl

This command starts the recovery package.

7.Verify that the recovery package starts up successfully in the recovery cluster.

8.Halt the recovery package using the cmhaltpkg command.

9.Resume replication from the primary cluster to the recovery cluster.

Run the following commands from DC3 node to overwrite any changes on the recovery cluster disk array and resume the replication:

#pairsplit -g <Active-CAJ-pair> -RB

#pairresync -g <Active-CAJ-pair> -c 15

These commands discard changes that were done at the recovery cluster and start synchronizing the Continuous Access Journal group data.

10.If Delta Resync pair is deleted as part of Step 2:

•Re-create the Delta Resync pair deleted in Step1 using the paircreate command from DC3 node:

# paircreate -g <Delta Resync-pair> -vr –f async –jp <Journal_id> -js <Journal-id> -nocsus

•Assign Remote Command devices to journal volumes of Delta Resync pair using Remote Web Console. For details on assigning remote command devices to journal volumes, see “Assigning Remote Command Devices to Journal Volumes” (page 440).

11.Start the primary cluster using the cmruncl command.

12.Start the primary package using the cmrunpkg command.

Automatic Failover between DC1 and DC2

All failover operations in the primary cluster of the 3DC DR Solution are similar to a regular Two Data Center (2DC) Metrocluster environment configured using Continuous Access Synchronous/Journal replication appropriately.

When using Tri-Link configuration, during the failover of a package from DC1 to DC2, the replication to the DC3 site is retained using the same Active-CAJ-pair that was being used before the failover. For example, the application package is running on DC1 and the data is being replicated to DC3 from DC2 (i.e. Multi-hop topology). Upon the failure of application on all nodes in DC1, the application package fails over to a node in DC2. As part of package startup, the data replication between DC1 and DC2 is reversed and the data starts replicating from DC2 to DC1. The replication to DC3 will be continued from DC2 (i.e. Multi-target topology). The same Active-CAJ pair (DC2-DC3 pair) is used even after the failover to replicate the data to DC3 as shown in Figure 83 (page 464).

Figure 83 Package Failover with data being replicated to DC3 from DC2

464 Designing a Three Data Center Disaster Recovery Solution