
NOTE: Specify the condition as != DOWN with a space before the word Down. Ignoring the space will cause the cfsdgadm command to fail.
If you have SLVM configured in your environment, add the EMS resource details in RAC database package configuration file.
RESOURCE_NAME /dts/mcsc/hrdb_sc
RESOURCE_POLLING_INTERVAL 120
RESOURCE_UP_VALUE != DOWN
RESOURCE_START automatic
You must apply the modified RAC database package configuration using the cmapplyconf command.
2.Verify the Site Safety Latch resource configuration at both sites. Run the cfsdgadm ls command.
cfsdgadm show_ems hrdbdg
RESOURCE_NAME/dts/mcsc/hrdb_sc
RESOURCE_POLLING_INTERVAL 40 RESOURCE_UP_VALUE != DOWN
cfsdgadm show_ems flashdg
RESOURCE_NAME/dts/mcsc/hrdb_sc
RESOURCE_POLLING_INTERVAL 40 RESOURCE_UP_VALUE != DOWN
If you have SLVM configured in your environment, run the following command to view the EMS resource details:
cmviewcl
3.Configure the Site Controller Package with the RAC MNP stack packages of both sites.
site san_francisco critical_package managed_package managed_package managed_package managed_package
sfo_hrdb sfo_hrdb_dg sfo_hrdb_mp sfo_flash_dg sfo_flash_mp
site | san_jose |
|
| critical_package sjc_hrdb | |
| managed_package | sjc_hrdb_dg |
| managed_package | sjc_hrdb_mp |
| managed_package | sjc_flash_dg |
| managed_package | sjc_flash_mp |
|
|
|
NOTE: Do not add any comments after specifying the critical and managed packages.
4.
cmapplyconf
After applying the Site Controller Package configuration, run the cmviewcl command to view the packages that are configured.
Starting the Disaster Tolerant RAC Database in the Metrocluster
At this point, you have completed configuring SADTA in your environment with the Oracle Database 10gR2 RAC. This section describes the procedure to start the disaster tolerant RAC database in the Metrocluster.
Complete the following procedure to start the disaster tolerant RAC database:
380 Designing a Disaster Recovery Solution Using Site Aware Disaster Tolerant Architecture