ASSEMBLY
Cable adjustment
•Throttle cable should be paralleled to flexible shaft. In case of twisting, they should be restored by parallel.
•Throttle cable should be adjusted under the bended flexible shaft as shown.
Adjusting the harness and brush cutter
WARNING! |
When working with the brush cutter the |
! harness should always be worn. If this is |
1)Loosen the
mmplay between cable lug and slotted fittings when the throttle trigger is fully depressed.
2)When the throttle cable is adjusted correctly, tighten the
|
not done, you cannot control the brush |
cutter safely and this can result in injury to |
yourself or someone else. Never use a |
harness with a defective quick release |
catch. |
Quick release
On the front is an easily accessible, quick release catch:
•Pull out the red strap.
•The hip strap and one shoulder strap will be automatically released at the same time and the harness and the engine
unit will slide to the ground.
Use this if the engine should catch fire or in any other emergency situation when you quickly need to take off the harness and machine.
Equal load on shoulders
A well matched saw and harness make work much easier. Adjust the harness to give the best working stance. Adjust the side straps so that the weight is equally divided across the shoulders.
16 – English
