Husqvarna SG13A Engine, Throttle

Engine

Exterior engine components and controls.

1. Throttle

2. Starter

3. S t arter handle

4. Fuel valve

5. Choke control

6. Air filter

7. S park plug

8. Muffler

9. Oil dipstick

10. Oil drainage

11. Oil level guard

12. Engine switch - disconnected use switch on

handle bar

13. Fuel tank

14 . Fuel filler cap

CONTROLS

The lever on the engine is normally not used. It is

connected to the throttle on the handle. If the cable

should bind or break, you can reduce the throttle

with the lever on the engine as an emergency

measure to slow the engine speed to an idle and

stop the cutting wheel.

8011-126

8011-273chg

8011-034

1. THROTTLE LEVER

911

Contents

Main Page TABLE OF CONTENTS Stump Grinder SG13A INTRODUCTION SYMBOLS AND DECALS IMPORTANT INFORMATION Decals and machine-bound instructions SYMBOLS AND DECALS Location of decals T ranslation of instructions General use Page Preparations Operating Movement/Transport Storage Children Fuel system WARNING! Maintenance WARNING! PROTECTIVE EQUIPMENT Personal equipment Equipment set-up Page Page Presentation Main components and operating controls Engine Throttle Starter Starter handle Fuel valve Choke control Air filter Spark plug Muffler Oil dipstick Oil drainage Fuel tank Cutting unit Dead man s grip bar Throttle On/Off Engine switch on the panel Brake Adjustment bar for the handle Starting the engine Page Normal shutdown Shutdown in emergency situations Page Page 6. 5. Operating on hills Transport Maintenance schedule Cleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustment Ignition system Adjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Adjusting the brake Two minute rule Cleaning and washing 1 . Blade shaft bearings 2 . Engine oil 3. Right wheel 4. Throttle cable TROUBLESHOOTING Page STORAGE Winter storage Service TECHNICAL DATA WIRING DIAGRAM SERVICE JOURNAL Delivery service After the first 20 hours