IGSV-ASCS-0303

Maintenance (continued)

NOTE: Before making any of the recommended adjustments, Verify that the case(s) have been leveled properly.

Tech/glassadj/970602 tn

Adjust glass Up and Down

1. Remove

2. Lift open

3. Loosen hex screw

 

(vertically)

top glass

glass panel(s)

(1/4" allen).

 

 

and panel

and relieve

Remove chrome

A

 

 

enclosing

tension on

access cap in order

 

 

mini-top

hinge.

to hold nut plate.

 

 

hardware.

 

 

4. Add or remove

5. Close glass panel(s)

shims as needed.

and check alignment

(see note on shims

Retighten hex screw

below)

and reinstall removed

 

components.

NOTE: Standard shim thickness is 1/16"

 

 

 

 

nut

Back

 

 

 

 

plate

 

 

 

 

of Case

 

 

 

 

 

 

 

 

Inside

 

 

 

 

 

of Case

 

CUT VIEW:

 

 

 

 

Chrome cap

 

 

 

 

Mini Top

 

 

 

 

for access to

Hardware

 

 

 

 

nut plate

 

 

 

 

 

 

RGSDS hardware shown

 

 

 

Adjust glass Side to Side

1. Remove

2. Lift open

3. Loosen (4mm)

4. Move panel

 

(horizontally)

top glass

glass panel(s)

screw slightly.

as required

 

 

enclosing

and relieve

one at each hinge

Retighten components

 

B

mini-top

tension on

 

 

 

 

hardware.

hinge.

 

 

 

Adjust glass Front to Back

1. Remove

2. Estimate

3. Lift open

4. Loosen hex screw

 

 

top glass

amount of

glass panel(s)

(1/4" allen) slightly.

C

 

and panel

adjustment

and relieve

Remove chrome

 

 

enclosing

and make

tension on

access plate in order

 

 

 

 

mini-top

pencil mark

hinge.

to hold nut plate.

 

 

hardware.

on the mini-cam.

 

5.Slide the mini-top forward or backward to the mark in step 2. Check alignment of glass.

Retighten components.

18