![](/images/backgrounds/223060/bg2d.png)
C
H
4
87
C A M E R A
C
H
4
86
C A M E R A
FLASH (OPTIONAL ACCESSORY)1. Remove the protective cap.
- Hold the flash unit securely between thumb and
pointer finger. With other hand, place thumb over
plastic protective cap and press downward.
(similar to if you were breaking in half,
see figure 1).
2. Install the protective cap.
The protective cap has securing feet on either side.
Place (1) securing foot in one end of groove then
press other foot (2) upwards into groove.
3. Open the earphone microphone terminal cap
to expose the port.
4. Insert the flash into the earphone microphone port.
The front of the flash should be facing the object
of photography.
5. Set up the flash on the camera menu.
(Refer to the User Guide TX-95C for flash set up.)
6. Press the shot button to light a flash bulb. (About 3.5 seconds are
taking for an electric charging.)
TO USE FLASH
You should be at least 2 feet (about 60cm) away from object
of photography to ensure proper lighting. If you are too close
the picture will come out white.
lUse it in a room temperature.It may not light on or charge under
5°C or above 35°C.
lDo not use it in a damp area.
lUsing in a high or low temperature may cause shorten of the
mobile flash life or extend the charging time.
lClean up the plug with a cotton stick. Dust in the plug may cause
irregular charging.
lIf the mobile flash repeats to radiate, the intensity of radiation is
shortening and the images are darkening. If the intensity of
radiation is decreasing, buy another flash.
lInsert the terminal of mobile flash to the ear phone jack. It may
cause some noise while using phone.
lDo not use it while driving a car. It may cause a car accident.
lDo not flash near your eyes. It may cause a bad sight.
lDo not place it near children. They may receive an electric shock
by putting it in their mouths.
lIf some parts of fit are exposed by falling or breaking up, do not
touch the exposed parts. You may receive an electric shock.
lIf it generates heat, smells bad or is damaged, pull it out
immediately. It may cause an explosion or fire.
lDo not disassemble, reconstruct or repair it since it contains a high
voltage circuit. Visit a service center for repair.
lDo not use or put it near fire, stove, or high temperature areas.
To may cause an explosion or fire.
lDo not wet it by sweat, water or salt water. If the substrate gets
wet, it may cause an explosion or fire. If it gets wet, turn off the
power and visit a service center.
lDo not place it in a damp area like a bathroom. It may cause an
explosion or fire.
lDo not heat or dry it with drier if it gets wet.
lDo not place a cup or vase near it. Spilling liquid on it may cause
an explosion or fire.
lDo not drop.
lDo not touch it with plug (metal part). It may cause an explosion or
fire.
lUse it only with approved Hyundai handsets.
HINTS FOR USING FLASH
To protect the user, others and their property, here are
important hints for using the flash safely.
Please read it carefully and follow the usage instructions.