HC1 to HC2 Upgrade
The information contained in this document is to be used by customers who are planning to upgrade their InfoPrint
The HC1 has eight 1.27 mm (0.4 inch) printheads with 96 inkjets each and the HC2 has eight 2.72 cm (1.06 inch) printheads with 256 inkjets each . The upgrade affects the following:
1.Applications
2.Supplies and Features
3.Installation
Applications and Machine Setup
The HC1 applications are compatible with the HC2.
The Setups for the HC1 must be saved (Con®gure HCPP) before the installation starts. When the HC2 has been tested, the Setups are read (Con®gure HCPP).
The InfoPrint 4000 must be at level 8.523 or higher.
Supplies and Features
The HC1 supplies and features are not compatible with the HC2. These include ink, ink reservoir, and printheads. The upgrade installs one HC2 ink reservoir and eight HC2 printheads. Additional reservoirs and printheads are not included in the base upgrade. If additional ink reservoirs and/or printheads are required, these need to be ordered separately.
Note: HC1 ink is not compatible with the HC2 ink, because HC1 ink causes severe damage to the HC2. Do not use HC1 ink in the HC2 ink reservoir.
New ink must be available at the account before the planned installation date.
Custom colors must go through the design process for the new ink.
Installation
The installation of the upgrade takes approximately 1 week. The installation activity requires working space. This means the following:
1.There are two methods for the upgrade
v Removing the HC1 from its current location so that the InfoPrint 4000 can still be used during the upgrade installation.
±Time to remove the HC1 from its current position and move the
±Time to move the
© Copyright IBM Corp. 1997 | 1 |