IBM A40P TYPE 6841, A40I TYPE 2271, A40 TYPE 6840 manual

Diagnostic Error Code	FRU/Action
014-001-XXX	1.	Remove external parallel device, if
Parallel port Presence
		present
	2. Run setup, enable port
	3.	System board
014-002-XXX	1.	System board
014-003-XXX
Parallel port Timeout/Parity error
014-013-XXX	1.	System board
014-014-XXX
Parallel port Control Signal/Loopback test
failure
014-015-XXX	1.	Wrap plug
Parallel port External Loopback failure
	2.	System board
014-027-XXX	1.	Run Setup, enable port
Parallel port Configuration/Setup error
	2.	Flash the system
	3.	System board
014-03X-XXX	1.	System board
014-04X-XXX
Parallel port failure
014-195-XXX	1.	Information
Parallel port Test aborted by user
	2.	Re-start the test, if necessary
014-196-XXX	1.	Press F3 to review the log file
Parallel port test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
014-197-XXX	1.	Make sure the component that is called
Parallel port test warning
		out is connected and/or enabled
	2. Re-run test
	3. Component that is called out in warning
		statement
	4.	Component under test
014-198-XXX	1.	If a component is called out, make sure
Parallel port test aborted
		it is connected and/or enabled
	2. Flash the system and re-test
	3. Go to the ″Undetermined problems″
		section
014-199-XXX	1.	Go to the ″Undetermined problems″
Parallel port test failed, cause unknown
		section
	2. Flash the system and re-test
	3. Replace component under function test
014-2XX-XXX	1.	External parallel device
014-3XX-XXX
	2.	System board
Parallel port failure
015-000-XXX	1.	No action
USB port Interface Test Passed
015-001-XXX	1.	Remove USB device(s) and re-test
USB port Presence
	2.	System board

46Hardware Maintenance Manual A40 Type 6840 A40P Type 6841 A40i Type 2271: IBM NetVista Computer