Symptom/Error | FRU/Action | |
|
|
|
No beep during POST. | 1. | See “Undetermined problems” on page |
| ||
|
| 75. |
| 2. | System Board |
| 3. | Memory Module |
| 4. | Any Adapter or Device |
| 5. | Riser Card |
| 6. | Power Cord |
| 7. | Power Supply |
|
|
|
POST error codes
Each time you
vChecks some basic
vChecks the memory operation
vStarts the video operation
vVerifies that the diskette drive is working
vVerifies that the hard disk drive is working
If the POST finishes without detecting any problems, a single beep sounds and the first screen of the operating system or application program appears.
Note:
Type 2271/6840/6841 computers default to come up quiet (no beep and no memory count and checkpoint code display) when no errors are detected by POST.
To enable beep and memory count and checkpoint code display when a successful POST occurs, do the following:
1.Select Start Options in the Configuration/Setup Utility program (see “Setup Utility program” on page 7).
2.Set
If the POST detects a problem, an error message appears on the screen. A single problem can cause several error messages to appear. When you correct the cause of the first error message, the other error messages probably will not appear on the screen the next time you turn on the system.
In the following index, X can represent any number.
POST Error Code | FRU/Action | ||
|
|
| |
000 | 1. | Verify adapter device and Bus Master | |
SCSI Adapter not enabled | |||
| fields are enabled in PCI configuration | ||
|
| ||
|
| program. See documentation shipped | |
|
| with computer. | |
|
|
| |
02X | 1. | SCSI Adapter | |
| |||
|
|
|
Chapter 6.