IBM A40 TYPE 6840, A40I TYPE 2271, A40P TYPE 6841 manual Select Automatic Hardware Power Management

If NO, continue to	.
If YES, proceed to	.

If the Power Management feature is enabled, do the following:

1.Start the Configuration/Setup Utility program (see “Setup Utility program” on page 7)

2.Select Power Management from the Configuration/Setup Utility program menu.

3.Select APM.

4.Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (}) or Right Arrow (Æ) to change the setting.

5.Select Automatic Hardware Power Management.

6.Set Automatic Hardware Power Management to Disabled.

7. If the problem persists, continue to .

Run diagnostics. If necessary, refer to “Diagnostics” on page 8.

vIf you receive an error, replace the part that diagnostics calls out or go to ″Symptom-to-FRU Index″ on page 37.

vIf the test stops and you cannot continue, replace the last device tested.

2Hardware Maintenance Manual A40 Type 6840 A40P Type 6841 A40i Type 2271: IBM NetVista Computer