Flash (BIOS/VPD) update procedure
Attention:
Refer to the information label located inside the system unit cover for any
1.
2.Insert the flash update diskette into drive A.
3.
4.When the Update Utility appears; select the country/keyboard, then press Enter.
5.If the computer serial number was previously recorded, the number is displayed with an option to update it. Press Y to update the serial number.
6.Type the
7.Follow the instructions on the screen to complete the flash (BIOS/VPD) update procedure.
Flash recovery boot block jumper
Attention:
If an interruption occurs during a Flash/BIOS upgrade, the BIOS might be left in an unusable state. The Boot Block jumper enables you to restart the system and recover the BIOS.
To perform a Flash/BIOS recovery using the recovery jumper, use the following procedure.
1.
2.Move the system board recovery jumper to the clear position. Refer to “A40/A40P/A40i system board layout” on page 29 or the label inside the computer for more information.
3.Insert the upgrade diskette into the diskette drive.
4.
5.When the Flash Update Utility appears, select the country/keyboard, then press Enter.
6.If the computer serial number was previously recorded, the number is displayed with an option to update it. Press Y to update the serial number.
7.Type the
8.Follow the instructions on the screen to complete the flash (BIOS/VPD) update procedure.
9.When you are instructed to reboot the computer,
88Hardware Maintenance Manual A40 Type 6840 A40P Type 6841 A40i Type 2271: IBM NetVista Computer