4
15
FREQUENCY SETTING
n When first applying power (CPU resetting)
Before first applying power, make sure all
connections required for your system are complete
by referring to Chapter 3. Then, reset the transceiver
using the following procedure.
Resetting CLEARS all programmed contents in
memory channels and returns programmed values
in quick/initial set mode to default values.
q Make sure the transceiver power is OFF.
w While pushing and holding [∫ UP] and [√ DN],
push [PWR] for 1 sec. to turn power ON.
• The internal CPU is reset.
• The transceiver displays its initial VFO frequencies
when resetting is complete.
e All quick/initial set mode settings are returned to
default values. (p. 41)
n Initial settings
After resetting the transceiver, set controls and
switches as shown in the figure below.
[PWR] [Z][Y]
[METER]: Po
[LOCK]: OFF
[POWER]: OFF [P.AMP], [ATT],:
OFF
[RIT]: Center
[IF SHIFT]: Center
[AF]: Max. CCW
[RF/SQL]: 12 o'clock
[NB], [COMP]:
OFF
Turn power ON, then check the display. If any of the
following indicators appear, turn them OFF as follows:
• Quick tuning step indicator “Z” : Push [TS].
• 1 Hz frequency readout :
Push [TS] for 1 sec.
( while quick tuning
step is OFF)
• RIT indicator “
RIT
” : Center.
• Split indicator “ ” : Push [SPL].
Under cooler temperatures, the LCD may appear
dark and unstable after turning power ON. This is
normal and does not indicate any equipment
malfunction.
CCW : counterclockwise