GETTING TO KNOW YOUR WATER DISPENSER

Cooling tank for the cold water, made of stainless steel.

For the hot water there is a stainless steel heavy duty hot water tanks with an external heater. It is suitable for mineral water.

Thermostat on the rear panel.

Two switches on the rear panel : one for the hot water, one for the cold water.

All water ways are made from stainless steel

Refrigeration compressor is quiet and durable.

The power cord has a grounded plug. Please make sure that your outlet is properly grounded.

Integrated No-Spill system for added hygiene and convenience.

There are two high-flow taps on the front. The tap handles are color-coded.

Red is for hot, blue for cold water.

The hot water tap handle has a child resistant hot water guard. To operate it, squeeze the handle and locking device together and then push them down

Easy to clean deep drip tray

PREPARING YOU WATER DISPENSER

▌

 

1- Make sure that the water dispenser is not plugged into the electrical outlet.

 

2- Hold the water bottle vertically and upside down and place the water bottle

 

into the no-spill bottle receptacle. Apply slight pressure in order to pierce the

 

bottle cap with the spigot. It is no advisable to make any adjustments to the

 

thermostat setting before the water dispenser and bottled water are warmed

 

up to normal room temperature. This unit accepts two, three or five gallon

PLACE

water bottles.

BOTTLE

3- Open the two taps to let air out , until the water starts to flow. When

VERTICALLY

this happens, release the buttons.

STRAIGHT

4- Plug the water dispenser into a grounded power outlet and turn the

 

power switches on.

 

5- If the water dispenser is brought in from outside in the winter time, give it

 

few hours to warm up to room temperature before plugging it in. The

 

thermostat setting may be affected by coldness of the water dispenser itself

 

or the bottled water.

 

-The refrigeration thermostat is factory set between 7°C and 8°C (44.6°F and 46.4° F).

-The hot water thermostat is factory set between 88°C adn 89°C (190.4°F and 192.1°F).

-Before the water dispenser leaves the factory, the thermostat is set properly. It is not advisable to adjust the thermostat when using the water dispenser.

NOTE :

When your water dispense is in operation there is a small amount of water in the water passage between the water tanks and the taps.This water is not controlled by the cold or hot temperature settings. We recommend that in order to fully enjoy the desired water setting, you should eliminate this small amount, 200ml

- 400ml (6.76 fl .oz-13.52 fl.oz) using a small glass container.

2