6.Upgrade the projector's system software. Browse to the C300 Software webpage to download the software and upgrade instructions.
If the projector still will not display the image, it is likely that there is an internal problem that requires repair. Take the projector to your dealer or contact ASK Proxima Technical Support.
The video image is 'torn', distorted, noisy, or shifted. The edges of the image may be distorted.
1.Make sure that the cables are securely connected, and that the video source is good.
2.Reset the projector to factory defaults. To do this, go to Basic>Setup>Service>Factory Reset. All settings except lamp hours and network settings revert to default.
3.Make sure the Keystone setting is set to 50 (zero correction). You can check this in the projector menus. Go to Picture>Keystone, and adjust as necessary. For more information about keystone correction, see The image is not perfectly rectangular. ("Keystoning")
4.Try projecting on a different surface (for example, a plain, white wall).
If the projector still will not display the proper image, it is likely that there is an internal problem that requires repair. Take the projector to your dealer or contact ASK Proxima Technical Support.
Can I use the projector to display HDTV?
Yes, the projector can display a 1080i or 720p HDTV through VGA, DVI and BNC as RGBHV only. It will not accept RGB component. If you have a component HDTV source, you will need to purchase a
Can I connect a component video signal to this projector?
Yes, through the 5 BNC connectors labeled “Y, Pb, Pr, H, V”. Consult the Video Connections Chart for more information.
Can I connect more than one video source to this projector and switch between them?
Yes. You can connect composite,
Copyright ©
All Rights Reserved.