Cannot play | The disc was | Finalize the disc. See “Disc | |
disc a | recorded in Video | ||
recorded on | mode |
| |
your |
|
| |
Some players will | No solution | ||
recorder on | |||
another | not play even a |
| |
DVD player. | finalized disc |
| |
| recorded in Video |
| |
| mode |
| |
|
|
| |
| The disc was | The other player must be RW | |
| recorded in VR | compatible in order to play the | |
| mode | disc | |
|
|
| |
| Discs recorded with | No solution | |
|
| ||
| cannot be played on |
| |
| other players |
| |
|
|
| |
Cannot | The remaining blank | Use another disc | |
record or | space on the disc is |
| |
did not | insufficient |
| |
record |
|
| |
successfully |
|
| |
|
|
| |
| The source you are | You cannot record the source | |
| trying to record is |
| |
|
| ||
|
|
| |
| When recording to a | Use a VR mode formatted disc | |
| Video mode disc, | for | |
| programs that are |
| |
|
| ||
| protected cannot be |
| |
| recorded |
| |
|
|
| |
Stereo | Recorder A/V Out | Make A/V connections. Stereo | |
Audio | jacks are not | is available only on A/V output | |
Record or | connected to TV | from recorder. | |
Playback is | A/V In jacks |
| |
not present |
|
| |
|
|
| |
| Recorder | Select AUX or A/V source as | |
| Audio/Video Out is | TV input | |
| not selected for |
| |
| viewing at the TV |
| |
|
|
|
Maintaining
Care and handling of discs
Handling discs
Do not touch the playback side of the disc. Hold the disc by the edges so that fingerprints do not get on the surface. Never stick paper or tape on the disc.
Storing discs
After playing, store the disc in its case. Do not expose the disc to direct sunlight or sources of heat and never leave it in a parked car exposed to direct sunlight.
Cleaning discs
Fingerprints and dust on the disc can cause poor picture quality and sound distortion. Before playing, clean the disc with a clean cloth. Wipe the disc from the center out.
Do not use strong solvents such as alcohol, benzine, thinner, commercially available cleaners, or
Note
Never operate this product immediately after moving it from a cold location to a warm location. Leave it for two or three hours without operating it. If you use this product in such a situation, it may damage tapes, discs, or internal parts.
Resetting the recorder
Reset your recorder if you observe any of the following symptoms:
•When the recorder is plugged in, but the power will not turn on or off.
•When the display window does not working.
•When the recorder does not operate normally.
To reset the recorder:
•Press and hold the POWER button for more than five seconds. This forces the recorder to turn off. Press the POWER button again to turn the recorder back on.
- OR -
Unplug the power cord and then plug the power cord again after more than five seconds.
Specifications
General
Power requirements | AC 120V, 60 Hz |
Power consumption | 24W |
Dimensions (approx.) | 16.9 × 3.1 × 10.2 in. |
(w × h × d) | (430 × 78.5 × |
| 266 mm) |
Mass (approx.) | 10.14 lbs (4.6 kg) |
Operating temperature | 41°F to 95°F |
| (5°C to 35°C) |
Operating humidity | 5% to 90% |
Signal system | NTSC |
30 |