The remote

There is an obstacle

Remove the obstacle.

control does

in the path of the

 

not work

remote control and

 

correctly

your recorder.

 

 

 

 

 

The batteries in the

Replace the batteries with

 

remote control are

new ones.

 

exhausted.

 

 

 

 

 

The remote control is

Point the remote control at

 

not pointed at the

the remote sensor of your

 

remote sensor of

recorder.

 

your recorder.

 

 

 

 

 

The remote control is

Operate the remote control

 

too far from your

within 23 ft (7 m).

 

recorder.

 

 

 

 

Timer

The recorder clock is

Set the clock to the correct

recording is

not set to the correct

time.

not possible

time.

 

 

 

 

 

The timer has been

Reprogram the timer.

 

programmed

 

 

incorrectly.

 

 

 

 

 

The TIMER Record

Reprogram the Timer and

 

indicator light does

turn off your recorder to

 

not appear after

enable the timer.

 

programming the

 

 

timer.

 

 

 

 

Cannot play

The disc was

Finalize the disc. See “Disc

disc a

recorded in Video

Settings” on page 12.

recorded on

mode.

 

your

 

 

Some players will not

No solution.

recorder on

another

play even a finalized

 

DVD player

disc recorded in

 

 

Video mode.

 

 

 

 

 

The disc was

The other player must be RW

 

recorded in VR mode.

compatible in order to play

 

 

the disc.

 

 

 

 

Discs recorded with

No solution.

 

copy-once material

 

 

cannot be played on

 

 

other players.

 

 

 

 

Cannot

Not enough blank

Use another disc.

record or

space remaining on

 

did not

the disc.

 

record

 

 

successfully

 

 

 

 

 

 

The source you are

You cannot record the

 

trying to record is

source.

 

copy-protected.

 

 

 

 

 

When recording to a

Use a VR mode formatted

 

Video mode disc,

disc for copy-once material.

 

programs that are

 

 

copy-once protected

 

 

cannot be recorded.

 

 

 

 

Maintaining

Care and handling of discs

Handling discs

Do not touch the playback side of the disc. Hold the disc by the edges so that fingerprints do not get on the surface. Never stick paper or tape on the disc.

Storing discs

After playing, store the disc in its case. Do not expose the disc to direct sunlight or sources of heat and never leave it in a parked car exposed to direct sunlight.

Cleaning discs

Fingerprints and dust on the disc can cause poor picture quality and sound distortion. Before playing, clean the disc with a clean cloth. Wipe the disc from the center out.

Do not use strong solvents such as alcohol, benzine, thinner, commercially available cleaners, or anti-static spray intended for older vinyl records.

Note

Never operate this product immediately after moving it from a cold location to a warm location. Leave it for two or three hours without operating it. If you use this product in such a situation, it may damage discs or internal parts.

Resetting your recorder

Reset your recorder if you observe any of the following symptoms:

•When your recorder is plugged in, but the power will not turn on or off.

•When the display window does not working.

•When your recorder does not operate normally.

To reset your recorder:

•Press and hold the POWER button for more than five seconds. This forces your recorder to turn off. Press the POWER button again to turn your recorder back on.

Or, unplug the power cord and then plug the power cord again after more than five seconds.

24

www.insignia-products.com