15
Insignia 42" LED-LCD HDTV, 1080p
www.insigniaproducts.com
Connecting an antenna or cable TV (no box)
To connect an antenna or cable TV (no box):
1Make sure that your TV’s power cord is
unplugged, and all connected equipment is
turned off.
2Connect a coaxial cable to the ANT/CABLE jack
on the back of your TV and to the antenna or
cable TV wall jack.
3Plug your TV’s power cord into a power outlet,
turn on your TV, then turn on the cable or
satellite box.
4Go through the setup wizard on page 22.
Connecting a DVD or Blu-ray player
Using HDMI (best)
To connect a DVD or Blu-ray player using HDMI:
1Make sure that your TV’s power cord is
unplugged and the DVD or Blu-ray player is
turned off.
2Connect an HDMI cable (not included) to an
HDMI jack on the back or side of your TV and to
the HDMI OUT jack on the DVD or Blu-ray
player.
3Plug your TV’s power cord into a power outlet,
turn on your T V, then turn on the DVD or B lu-ray
player.
4Press INPUT to open the Input Source list.
5Press S or T to highlight HDMI1, HDMI 2,
HDMI3, then press ENT ER.
Note
• If the signal level for a channel is weak , the
picture may be distorted. Adjust the antenna or
use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels
and poor on others, the problem may be caused
by a poor or weak signal from the broadcaster
or cable TV provider.
• If you connect to cable or satellite TV without a
set-top box and experience poor picture quality,
you may need to install a set-top box to improve
signal reception and picture quality. Contact
your cable or satellite TV provider about
upgrading to a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as
it would be if the content was originally
recorded in HD.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
AUDIO OUTDIGITAL
OUTPUT ANT /CABLE VGA PC / DVI
AUDIO IN HDMI 1 / DVI HDMI 2
(ARC)
AUDI
O
O
U
T
DI
G
ITA
L
OUTPUT V
GA
P
C
/
DV
I
A
UDIO IN
H
DMI 1
/
DVI
HDMI
2
(ARC
)
Back of TV Coaxial cable
Note
You can also press HDMI repeatedly to select the
DVD or Blu-ray player.
Back of TV
DVD or Blu-ray player