8Pull the wires through the hole in the ceiling. Strip off the end of the outer wire jacket, then strip about ½ inch of the insulation from the ends of the wires.

9Connect the positive wire on your audio equipment to the red terminal on the speaker, then connect the negative wire on your audio equipment to the black terminal on the speaker.

Warning: Make sure that your audio equipment is turned off before you connect the speaker wires.

10Remove the speaker grill by pushing one of the Roto-Lock™ screws towards the front of the speaker, then insert the speaker into the hole in the ceiling.

11Tighten the screws evenly until the speaker is flat against the ceiling.

Caution: If you use a drill to tighten the screws, make sure that you set the drill to its lowest torque speed. Do not overtighten screws.

12Reinstall the speaker grill.

Painting the speakers and grills

The speakers have a weather resistant, ABS finish that you can paint.

To paint the speakers and grills:

1Remove the grills from the speakers.

2Make sure that the interior of the speaker is covered so no paint will get inside.

3Insert one of the supplied paint plugs into the speaker to protect the speaker.

4Carefully paint the exposed part of the speaker. Remove the plug when you have finished painting.

5Spray the grill with thin paint (5 parts thinning agent to 1 part paint). Make sure that you do not plug the screw holes on the grill with paint. Too much paint may adversely affect the speaker sound.

Specifications

Woofer 6 1/2”

Gold aluminum cone with a rubber

 

surrounding

Tweeter

¾” pivoting gold aluminum dome

Frequency

50 Hz to 20 kHz ± 3dB

response

 

Efficiency

90 dB 1w 1m

Power

5 watts minimum to 100 watts maximum

Impedance

8 ohms nominal

Grill metal

8.98” (228 mm) diameter × 3.70” (94 mm)

dimensions

depth

Cut-out dimension

7.68” (195 mm) diameter

Weight

6.9 lbs (3.12 kg) per pair

Outils requis

Crayon

Scie à guichet ou pour cloison sèche Tournevis cruciforme

Petit niveau

Câble de suspension ou cintre Outil à dénuder

Gants

Lunettes étanches Perceuse

Mèche plate de 1 po (si des poutres doivent être percées) Mèche de ¼ à ½ po (pour percer des trous d’essai)

Contenu de l’emballage

2 haut-parleurs Insignia

2cache-peinture

2grilles

1 gabarit

Installation des haut-parleurs au plafond

Pour un son stéréo

Installez les haut-parleurs avec un écartement de 6 à 10 pieds (1,8 à 3 m). Chaque haut-parleur doit être à la même distance de la zone d’écoute. Pour toutes instructions détaillées sur l’installation, voir « Instructions sur l’installation au plafond ».

Pour un son de cinéma maison

Installez les haut-parleurs avec un écartement de 6 à 10 pieds (1,8 à 3 m) et en arrière de 3 à 6 pieds (0,9 à 1,8 m) par rapport à la zone d’écoute. Pour toutes instructions détaillées sur l’installation, voire « Instructions sur l’installation au plafond ».

2