Insignia NS-LCD37HD-09 37" LCD TV

Connecting the power cord

To connect the power cord:

Plug the power cord into the AC IN jack on the back of your TV, then plug the other end into a power outlet.

Selecting the video input source

To select the video input source:

1Turn on your TV, then press INPUT. The INPUT SOURCE menu opens.

Using your TV

Turning your TV on or off

To turn your TV on or off (standby mode):

1Plug the power cord into a power outlet.

2Press (power). Your TV turns on.

3Press again to turn off your TV. When you turn off your TV, it goes into standby mode.

Warning

When your TV is in standby mode, it is still receiving power. To completely disconnect power, unplug the power cord.

Note

If your TV does not receive an input signal for several minutes, it automatically goes into standby mode.

Using the remote control

Point the remote control toward the remote control sensor on the front of your TV.

Make sure that no objects are between the remote control and the remote control sensor.

Do not expose the remote control to shock.

Do not expose the remote control to liquids or high humidity.

Do not place your TV in a location where sunlight or bright light shines on the remote control sensor. This can interfere with the signal from the remote control.

The following illustration shows the best angle for using the remote control.

16.4" (5 m)

2Press or to select the video source, then press ENTER. You can select:

TV

AV1

AV2

S-Video1

S-Video2

Component1

Component2

HDMI1

HDMI2

HDMI3

VGA

You can also select the input source using the following remote control buttons:

COMP—Press once to select Component1. Press twice to select Component2.

HDMI–Press once to select HDMI1. Press twice to select HDMI2. Press three times for HDMI3.

VIDEO—Press once to select AV1. Press twice to select AV2. Press three times for S-Video1. Press four times for S-Video2.

TV—Press to select TV.

Selecting the TV signal source

The first time you turn on your TV, you must select the TV signal source. Your TV stores this information.

You do not need to change the TV signal source unless it changes. For example, you change from an outside antenna to cable TV.

To select the TV signal source:

1Press MENU. The on-screen menu opens.

Picture

Time

Setup

Lock

Channel

Picture Mode

 

Standard

 

Contrast

 

 

 

50

Brightness

 

 

 

50

Color

 

 

 

50

Tint

 

 

 

0

Sharpness

 

 

 

50

Color Mode

 

Cool

 

 

Select

 

Move

MENU

Exit

www.insignia-products.com

11