Integra DSR-7.3 instruction manual Rear panel

Index to Parts and Controls

Rear panel

1 2 3 4 5 6 7 8

L

ANTENNA

SURROUND

FRONT SPEAKERS

PREOUT

IR

SPEAKERS

AC INLET

R

L

R

CENTER

L

AUDIO

REMOTE

IN

ANTENNA

CONTROL

R

AM

FM 75

SUB

IN

OUT

IN

WOOFER

TV/LINE

MD/CDR/TAPE

DIGITAL

VIDEO OUTPUT

OPTICAL

Y

PB

PR

OUT

IN

S VIDEO

VIDEO

COMPONENT

90

Shapes of jacks vary depending on the area in which it was purchased.

1SUB WOOFER PRE OUT jack [17, 18]

This terminal is for connecting an active subwoofer.

2TV/LINE IN jacks [16,19]

This terminal is for connecting audio output terminals of TV, VCR or other video equipment.

3MD/CDR/TAPE IN/OUT jacks [19]

These terminals are for connecting to the recording input and output terminals of an MD recorder, CD recorder or tape deck.

4 z REMOTE CONTROL connector [20]

Connect the Integra/Onkyo components that have z connectors such as a MD recorder, and cassette tape deck using the z cables provided with them. When these components are interconnected, they can be controlled from the remote controller provided with the DVD Receiver.

After connecting the z connectors, check the operation of the remote controller buttons for use in controlling other components.

5IR IN jack [21]

If the DSR-7.3 is located inside a rack or cabinet that will not allow infrared beams to reach the IR sensor, you will need to connect a remote sensor to IR IN jack to be able to use the remote controller. Then install the remote sensor in an unblocked location where you can easily point the remote controller.

6ANTENNA terminals [22, 23]

These terminals are for connecting the FM antenna and AM antenna.

7FRONT SPEAKERS, CENTER SPEAKER and SURROUND SPEAKERS terminals [18]

Speaker terminals are provided for the front left, front right, center, surround left and surround right speakers.

8AC INLET [24]

Connect supplied AC power cord to this terminal.

9DIGITAL OPTICAL IN/OUT jacks [16, 19]

These are the digital audio input and output jacks. The digital input works in combination with the analog TV/LINE IN jacks. Connect the digital output from your TV or satellite tuner (MD player, etc.) to DIGITAL OPTICAL IN. Set the Input Selector to TV/LINE IN to play the digital sound. Connect the DIGITAL OPTICAL OUT to a digital recording device (MD recorder, CD recorder, etc.). Do not connect the DIGITAL OPTICAL OUT if the digital output from the same component is connected to the DIGITAL OPTICAL IN.

0VIDEO OUTPUT (VIDEO/S VIDEO/COMPONENT) jacks [16]

The monitor output includes RCA type, S video and component configurations. This output is for connecting television monitor or projector.

14