Intel 480T - page 264

238
Intel® NetStructure™ 480T Routing Switch User Guide
configure rip Rxmode [none | v1only |
v2only | any] {vlan [<name> | all]} Changes the RIP receive mode for one or all VLANs. Specify:
•none—Drop all received RIP packets.
•v1only—Accept only RIP v1 format
packets.
•v2only—Accept only RIP v2 format
packets.
•any—Accept both RIP v1 and v2 packets.
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is any.
configure rip txmode [none | v1only |
v1comp | v2only] {vlan [<name> | all]} Changes the RIP transmission mode for one or all VLANs. Specify:
•none—Do not transmit any packets on this
interface.
•v1only—Transmit RIP v1 format packets to
the broadcast address.
•v1comp—Transmit RIP v2 format packets to
the broadcast address.
•v2only—Transmit RIP v2 format packets to
the RIP multicast address.
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is v2only.
configure rip updatetime {seconds} Changes the periodic RIP update timer. The
default setting is 30.
configure rip vlan [<name> | all] cost
<number> Configures the cost (metric) of the interface. The default setting is 1.
enable rip Enables RIP. The default setting is disabled.
Table 13.2: RIP Configuration Commands (continued)
Command Description