302
Intel® NetStructure™ 480T Routing Switch User Guide
Table16.5 describes the commands used to configure IPX/SAP.
For more command options, press the Tab key in the command line
interface.
configure ipxrip vlan [all | <name>] [import-
filter | export-filter | trusted-gateway] [none |
<access-profile>]
Configures the import, export, or trusted-
gateway options and specifies an access
profile.
configure ipxrip delete vlan [<name> | all] Disables IPX/RIP on one or all interfaces.
configure ipxrip vlan [<name> | all] delay
<msec> Configures the time between each IPX/RIP
packet within an update interval. The default
setting is 55 milliseconds.
configure ipxrip vlan [<name> | all] max-
packet-size <size> Configures the maximum transmission unit
(MTU) size of the IPX/RIP packet. The
default setting is 432 bytes.
enable ipxrip Enables IPX/RIP on the router.
configure ipxrip vlan [<name> | all] update-
interval <time> {hold-multiplier <number>} Configures the update interval and hold
multiplier for IPX/RIP updates. This setting
affects both the periodic update interval of
IPX/RIP and the aging interval of learned
routes.
The default update interval is 60 seconds. The
default multiplier is 3.The aging period is
calculated using the formula:
update-interval x multiplier = aging period
Table 16.4: IPX§ /RIP Configuration Commands (continued)
Command Description
Table 16.5: IPX§/SAP Configuration Commands
Command Description
configure ipxsap add vlan [<name> | all] Configures an IPX VLAN to run IPX/SAP
routing. If no VLAN is specified, all VLANs
are configured to run IPX/SAP routing. IPX/
SAP routing is enabled by default when the
IPX VLAN is configured.