Installation

Page 3-9

FDD: Floppy Controller Connector

IDE1: ATA-66/100 IDE Connector

Supports up to 2 IDE devices from embedded IDE

controller .

PW1
IDE1
FDD
PW2
When using two IDE drives, one must be set to
Master mode and the other to Slave mode. Refer to
your disk drive user’s manual for information about
selecting the proper drive switch settings.

PW1: 24-pin ATX Power Connector

PW2: 4-pin ATX12V Power Connector

The mainboard is equipped with a standard 24-pin

ATX main power connector and a 4-pin +12V

power connector for connecting an ATX12V

power supply. The plugs of the power cables are

designed to fit in only one orientation. Insert the

plugs into the connectors until they fit in place.

1
3
1
-12V3.3V
Ground+5V
PS-ON+5V
-5VPW-OK
+5V5VSB
+5V
+5V
Ground
+12V
+12V
3.3V
+12V+12V
23
11
4
2
3.3V3.3V
GroundGround
GroundGround
GroundGround
GroundGround
24
PW1PW2
The board requires a minimum of 350 Watt power
supply to operate. Your system configuration (amount
of memory, add-in cards, peripherals, etc.) may
exceed this minimum power requirement. To ensure
that adequate power, use a 400 Watt or greater power
supply.
IDE3
Caution:The PW1 and PW2 Power Connector must be used simultaneously .40 3921IDE134 3321FDD