SPEAKER CONNECTIONS
This amplifier can operate in one, two or three channel mode. The minimum impedance for single channel (bridged/mono) operation is 4 or 8 ohms. Tri channel power is referred to stereo and mono at the same time. Minimum impedance remains the same for three channel (front /subwoofer) systems as long as proper passive crossovers are used. Connect right and left speaker wire to corresponding speaker output terminals of the amplifier. Be sure to have the positive wire from the speaker connected to the positive speaker terminal of the amplifier and the negative wire from the speaker must connect with the negative speaker terminal of the amplifier. Reversing any of these connections will result in the speaker cones moving out of phase which causes bass cancellation. See Fig.3 Speaker Output Connections.
2 CH SPEAKER WIRING DIAGRAM
1 SPEAKER BRIDGED
8
| POWER | 2 CHANNEL AMPLIFIER | SPEAKER | |||
| B+ |
|
|
| ||
GND | REM | FUSE | CH1 | BRIDGED | ||
|
|
|
|
| CH2 | |
|
|
| 40A | 40A |
| |
|
|
|
|
|
| 4 - 8 Ohm |
|
|
|
|
|
| 1CH |
2 SPEAKER STEREO |
|
|
|
|
|
|
|
|
|
| 8 |
|
|
| POWER | 2 CHANNEL AMPLIFIER | SPEAKER | |||
| B+ |
|
|
| ||
GND | REM | FUSE | CH1 | BRIDGED | ||
|
|
|
|
| CH2 | |
|
|
| 40A | 40A |
| |
|
|
|
|
|
| 2 - 4 Ohm |
|
|
|
|
| 1 CH | 2 CH |
3 SPEAKER TRI MODE |
|
|
|
|
|
|
| POWER | 2 CHANNEL AMPLIFIER | SPEAKER | |||
| B+ |
|
|
| ||
GND | REM | FUSE | CH1 | BRIDGED | ||
|
|
|
|
| CH2 | |
40A 40A
| 4 - 8 Ohm |
|
1 CH | 2 CH |
|
| 3 CH |
|
| 4 - 8 Ohm | FIG.3 |
| WOOFER 2CH+1CH |
8
