41
J-300
1. Jets may all be closed. Verify all jets are in the open “on” position
(Sec. 10.5, page 26).
2. Pump may not be properly primed. This can happen after the spa is
drained and relled. Press the JETS 1 button on the control panel
several times, never leaving the motor running for more than 5 to 10
seconds at a time. Turn power off and let the air out of spa plumbing
system by removing the lter cartridge (Sec. 12.1, page 30). Make
certain you reinstall the lter cartridge before turning on spa power
and restarting the jets pump 1.
15.3 poor Jet action
Make sure all jets are in the full open “on” position (page • 26).
Press the JETS 1 button to make certain pump #1 is on.•
Verify all air controls are in the "on" position by pressing down on •
their Jacuzzi Logo (page 27).
Check for dirty lter. Clean, if necessary (Section 12.1, page • 30).
15.4 water is Too Hot
Reduce thermostat setting.
15.5 no Heat
1. Check thermostat setting.
2. Keep the spa cover in place while heating.
3. Check the settings to see if your spa is in economy ltration/heating
mode (page 28).
Should checking the above steps fail to correct the problem, please call
your Jacuzzi Hot Tub dealer so that they may arrange service. We build
the best spas in the industry. Nonetheless, we are always striving to
improve the quality and features of our products.
Your input as a Jacuzzi spa owner is a cherished part of this process. If
you have any comments or suggestions, or if you wish to be informed on
any new products for your spa, please write to us.
ConGraTulaTIons on your good taste and welcome to the happiest
and most relaxed family in the world!