Jensen VM9312HD

VM9312HD

Final Installation

After completing the wiring connections, turn the unit on to

confirm operation (ignition switch must be on). If unit does not

operate, recheck all wiring until problem is corrected. Once

proper operation is achieved, turn off the ignition switch and

proceed with final mounting of the chassis.

1. Connect wiring adapter to existing wiring harness.

2. Connect antenna lead.

3. Carefully slide the radio into the half-sleeve, making

sure it is right-side-up, until it is fully seated and the

spring clips lock it into place.

NOTE: For proper operation of the CD/DVD player, the

chassis must be mounted within 20° of horizontal. Make

sure the unit is mounted within this limitation.

4. Attach one end of the perforated support strap

(supplied) to the screw stud on the rear of the chassis

using the hex nut provided. Fasten the other end of the

perforated strap to a secure part of the dashboard either

above or below the radio using the screw and hex nut

provided. Bend the strap to position it as necessary.

CAUTION! The rear of the radio must be supported with

the strap to prevent damage to the dashboard from the

weight of the radio or improper operation due to

vibration.

5. Replace any items you removed from the dashboard.

Final ISO-DIN Installation

1. Remove trim ring.

2. Mount factory brackets on new radio using existing

screws from old radio.

3. Slide radio chassis into dash opening and secure.

4. Reinstall dash panel.

AS/PS

BAND DISPOPEN

LO/DX

EJECT

VM9312

PRESSAUDIO

SRC MUTE

FINAL INSTALLATION