E-20
LCD Display and On-Screen Content
On-Screen Content (continued)

Alarm Messages

Alarm messages are displayed on the DVD recorder’s LCD display and on the monitor when the recorder cannot obey a com-
mand. These messages will remain on-screen until the next operation is carried out.
CAUTION
If alarm messages such as “INVALID DISC” are displayed several times when a disc recorded using this DVD recorder or a
blank disk is inserted, there is a possibility that the disc itself has been damaged. In such a case, the damaged disc should be
replaced with a new one.
If the alarm messages continue to appear after replacing the disc, the problem may lie within the DVD recorder, and in such a
case, you are recommended to contact either the store where this DVD recorder was purchased or your JVC authorized dealer.
Monitor message LCD display
message Description
INVALID DISC INVALId dISC A disc other than specified was inserted.
NOT SUPPORT
DISC
NoT SUPPoRT A disc recorded using a different DVD recorder was inserted or played.
REC INHIBIT REC INH Recording was attempted using a disc on which no more data can be recorded.
The current disc is a non-finalized disc to which no more data can be recorded.
COPY INHIBIT CoPY INH Recording of a copy-protected signal was attempted.
DISC FULL dISC FULL All remaining space on the disc is used up during recording.
CELL OVER CELL oVER The number of cells for a single title exceeded 255.
This will be displayed when the recording time for a single title is exceeded as a
result of setting ENCODE QUALITY to a low quality, recording content with little
movement, or other similar factors.
OVERHEATING! oVERHEATING Displayed when the internal temperature of the set rises due to fan malfunction, etc.
In this case, immediately turn off the power and discontinue use. The power will
automatically shut down in about 20 minutes after the OVERHEATING display.
INVALID SYNC INVALId SYNC This is displayed if recording is discontinued when signals are interrupted and out of
sync during recording.
ERRoR This is displayed when playback or recording is stopped due to dirt or damage on the
disc. In this case, either clean the disc or replace it.
FAN STOP FAN SToP This is displayed when the fan stops.
000 min
04/05/06
11:20:00
TITLE 01 0:11:22
CHAPTER
01 0:11:22
REC
REC INHIBIT
Alarm messages:
Displayed when
DISPLAY from the
DISPLAY MENU
screen is set to
ON.
Alarm message
LCD display
Monitor screen