RECORDING – Setting time codes –Time code recording

This unit has a built-in time code reader/ generator. It records time codes during recording. It does not record the user’s bit.

Time codes are recorded according to the recording condition as follows:

Time codes are recorded in the REC RUN mode. (REC RUN: time codes run only during recording.)

Condition

Time code recording

Time code is preset with this unit.

• Time codes preset in the built-in time code generator are re-

 

corded. (First time only)

 

• When recording ends, the set time codes becomes void and

 

regeneration occurs.

 

 

Memo

 

 

 

 

mode is selected from the NDF/DF item of the TIME

 

 

The framing

 

 

CODE menu. (NTSC only)

 

 

 

 

Time code is not preset.

• It reads the time codes recorded on the tape and continues

 

 

recording time codes from these values. (Regeneration)

 

 

• If no time code is recorded, it starts from “00”.

 

 

* Sometimes, the time codes recorded at the beginning of the

 

 

tape may not be read.

 

Preset time codes.

button

 

DISPLAY

 

SET button

 

 

 

 

BARS

STILL

BLANK

 

MODE

MENU

 

 

AUDIO

MENU

SEARCH+

MUTING

button

 

 

 

button

 

 

OUT SEL.

 

SET

button

 

 

SEARCH–

OUT LEV.

button

 

 

 

PLAY button

 

 

 

 

EJECT

 

 

 

 

EJECT button

 

 

 

 

MENIU

B

 

REC

PLAY

PAUSE

 

DVCAM NTSC PAL REC INH.

 

 

PAUSE button

 

 

 

 

SEL.

CH-1/3

REW

STOP

SET

CH-2/4

FF

E

 

 

 

Y/C

BR-DV3000

 

 

FF button

 

REW button

 

 

STOP button

Memo

When the REC button is held down in the STOP mode, the value of the built-in time code generator is displayed.

Time codes are preset via the TIME CODE menu. It can be set via either the remote controller or the Main unit.

Press the OPERATE button on the Main unit or the remote controller to turn on the power and set the unit to the STOP mode.

*To set it with the main unit, first remove the cassette from the unit if it is loaded.

E-36