EN 19
Names of
special-effects
playback
TimeScan
Speed LP
Speed SP
Audio output
●When noise appears or the upper or lower part of the picture is distorted during TimeScan search, press and adjust
tracking with TV PROG + or – button.
●The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be
distorted.)
●To resume normal playback, press PLAY.
●When using the recorder's TIME SCAN SHUTTLE ring, the playback speed may not change in the correct step if it is turned
too fast.
●Picture and audio may become distorted when the recording speed changes. When this happens, resume normal playback
once, and then try using TimeScan again.
●The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with
LP recordings.)
●Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP
recordings, or depending on the tape being used.
●Picture may appear distorted in comparison to normal playback.
●Depending on the tape in use, noise may appear or the upper part of the picture may be distorted.
●In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.
●TimeScan sound quality will differ in comparison to normal playback.
●When material such as music videos where there is non-stop sound (very few breaks in the soundtrack) are viewed at 2x
normal speed, the audio playback may be faster than normal.
●When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
●Picture will be monochrome with an LP-recorded MESECAM tape during TimeScan.
●TimeScan does not work with NTSC playback.

If you don't want to hear TimeScan audio, set "TIME SCAN AUDIO" to "OFF" (See below).

TimeScan Audio
The audio output can be set ON/OFF during TimeScan. Select ON/OFF as required.
* The default setting is "ON".
1Press MENU to access the Main Menu screen.
2Move the highlight bar (pointer) to "MODE SET" by pressing %fi, then press OK or
#
.
3Move the highlight bar (pointer) to "TIME SCAN AUDIO"
by pressing %fi, then press OK or
#
to select "ON" or "OFF".
4Press MENU to return to the normal screen.
**Still mode cannot be engaged using the remote control's
@
or
#
button. Still mode can be engaged by
pressing the PAUSE button.
PREVIOUS PAGE
AV2 SELECT AV2
COLOUR SYSTEMPAL/NTSC
TIME SCAN AUDIO ON
[5∞] =
[MENU] : EXIT
MODE SET
B. E. S. T. ON
PICTURE CONTROL AUTO
AUTO TIMER OFF
O. S. D. ON
DIRECT REC ON
AUTO SP=LP TIMER OFF
POWER SAVE OFF
NEXT PAGE
[5∞] =
[MENU] : EXIT
Reverse Forward
Search Play Slow-Motion *Still Slow-Motion Play Search
-9x -7x -5x -3x -1x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 3x 5x 7x 9x
-7x -3x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 5x 9x
Audio is output. Audio is not Audio is Audio is not Audio is output.
output. output. output.